Building Disaster Recovery Serviceguard Solutions Using Continentalclusters for Linux B.01.00.00

ManualsBrandsHP ManualsSoftwareHP Serviceguard for Linux RH AS ProLiant Cluster

F Sample Continentalclusters ASCII configuration file

Sample Continentalclusters ASCII configuration file:

Section 1 of the Continentalclusters ASCII configuration file

###############################################################################

#### ####

#### CONTINENTAL CLUSTER CONFIGURATION FILE ####

#### ####

#### This file contains ContinentalClusters configuration data. ####

#### The file is divided into three sections, as follows: ####

#### ####

#### 1. Cluster Information ####

#### 2. Recovery Groups ####

#### 3. Events, Alerts, Alarms, and Notifications ####

#### ####

#### For complete details about how to set the parameters in ####

#### this file, consult the cmqueryconcl(1m) manpage or your manual. ####

#### ####

###############################################################################

#### ####

#### Section 1. Cluster Information ####

#### ####

#### This section contains the name of the continental cluster,name of ####

#### the state directory,followed by the names of member clusters and ####

#### all their nodes.The continental cluster name can be any string ####

#### you choose, up to 40 characters in length.The continentalclusters ####

#### state directory must be string containing the directory location. ####

#### The state directory must be always an absolute path. The state ####

#### directory should be created on a shared disk in the recovery ####

#### cluster. This parameter is optional, if maintenance mode feature ####

#### recovery groups is not required. This parameter is mandatory, ####

#### if maintenance mode feature for recovery groups is required. ####

#### Each member cluster name must be the same as it appears in the ####

#### Serviceguard cluster configuration ASCII file for that cluster. ####

#### In addition to the cluster name, include a domain name for the ####

#### nodes in the cluster. Node Names must be the same as those that ####

#### appear in the cluster configuration ASCII file. A minimum of two ####

#### member cluster needs to be specified. You may configure one ####

#### cluster to serve as recovery cluster for one or more other ####

#### clusters. ####

#### ####

#### In the space below, enter the continental cluster name, ####

#### then enter a cluster name for each member cluster, followed ####

#### by the names of all the nodes in that cluster.Following ####

#### the node names, enter the name of a monitor package ####

#### that will run the continental cluster monitoring software ####

#### on that cluster. It is strongly recommended that you use the ####

#### same name for the monitoring package on all clusters; ####

#### "ccmonpkg" is suggested. Monitoring of the recovery cluster ####

#### by the primary cluster is optional. If you do not wish to ####

#### monitor the recovery cluster, you must delete or comment out the ####

#### MONITOR_PACKAGE_NAME and MONITOR_INTERVAL lines that follow the ####

#### name of the primary cluster. ####

#### ####

#### After the monitor package name, enter a monitor interval, ####

#### specifying a number of minutes and/or seconds. The default is 60 ####

#### seconds, the minimum is 30 seconds, and the maximum is 5 minutes. ####

#### ####

#### Example: ####

#### ####

#### CONTINENTAL_CLUSTER_NAME ccluster1 ####

#### CONTINENTAL_CLUSTER_STATE_DIR /opt/cmconcl/statedir ####

#### ####

#### CLUSTER_NAME westcoast ####

#### CLUSTER_DOMAIN westnet.myco.com ####

#### NODE_NAME system1 ####

Section 1 of the Continentalclusters ASCII configuration file 73