Managing HP Serviceguard A.11.20.10 for Linux, December 2012

NOTE: The Script_Parameters section of the PACKAGE output of cmviewcl shows the
Subnet status only for the node that the package is running on. In a cross-subnet configuration,
in which the package may be able to fail over to a node on another subnet, that other subnet is
not shown (see “Cross-Subnet Configurations” (page 27)).
7.1.11.2 Quorum Server Status
If the cluster is using a quorum server for tie-breaking services, the display shows the server name,
state and status following the entry for each node, as in the following excerpt from the output of
cmviewcl -v:
CLUSTER STATUS
example up
NODE STATUS STATE
ftsys9 up running
Quorum Server Status:
NAME STATUS STATE
lp-qs up running
...
NODE STATUS STATE
ftsys10 up running
Quorum Server Status:
NAME STATUS STATE
lp-qs up running
7.1.11.3 Status After Halting a Package
After we halt pkg2 with the cmhaltpkg command, the output of cmviewcl-v is as follows:
CLUSTER STATUS
example up
NODE STATUS STATE
ftsys9 up running
Network_Parameters:
INTERFACE STATUS NAME
PRIMARY up eth0
PRIMARY up eth1
PACKAGE STATUS STATE AUTO_RUN NODE
pkg1 up running enabled ftsys9
Policy_Parameters:
POLICY_NAME CONFIGURED_VALUE
Failover configured_node
Failback manual
Script_Parameters:
ITEM STATUS MAX_RESTARTS RESTARTS NAME
Service up 0 0 service1
Service up 0 0 sfm_disk_monitor
Subnet up 0 0 15.13.168.0
Generic Resource up sfm_disk
Node_Switching_Parameters:
NODE_TYPE STATUS SWITCHING NAME
Primary up enabled ftsys9 (current)
Alternate up enabled ftsys10
NODE STATUS STATE
ftsys10 up running
Network_Parameters:
INTERFACE STATUS NAME
PRIMARY up eth0
PRIMARY up eth1
198 Cluster and Package Maintenance