Managing HP Serviceguard for Linux Ninth Edition, April 2009

later if it fails. Enter no to keep Serviceguard from automatically starting the
package.
• node_fail_fast_enabled. Enter yes to cause the node to be halted (system halt) if the
package fails; otherwise enter no.
• run_script_timeout and halt_script_timeout. Enter the number of seconds Serviceguard
should wait for package startup or shutdown, respectively, to complete; or leave
the default, no_timeout. See (page 199).
• successor_halt_timeout. Used if other packages depend on this package; see “About
Package Dependencies” (page 121).
• script_log_file (page 200).
• log_level (page 200).
• failover_policy (page 201). Enter configured_node or min_package_node. .
(This parameter can be set for failover packages only.)
• failback_policy (page 201) . Enter automatic or manual.
(This parameter can be set for failover packages only.)
• If this package will depend on another package or packages, enter values for
dependency_name, dependency_condition, dependency_location, and optionally priority.
See “About Package Dependencies” (page 121) for more information.
NOTE: The package(s) this package depends on must already be part of the
cluster configuration by the time you validate this package (via cmcheckconf;
see “Verifying and Applying the Package Configuration” (page 219)); otherwise
validation will fail.
• To configure package weights, use the weight_name and weight_value parameters
(page 203). See “About Package Weights” (page 128) for more information.
• Use monitored_subnet to specify a subnet to be monitored for this package. If there
are multiple subnets, repeat the parameter as many times as needed, on a new line
each time.
In a cross-subnet configuration, configure the additional monitored_subnet_access
parameter for each monitored_subnet as necessary; see “About Cross-Subnet
Failover” (page 141) for more information.
• If your package will use relocatable IP addresses, enter the ip_subnet and ip_address
addresses. See the parameter descriptions (page 205) for rules and restrictions.
In a cross-subnet configuration, configure the additional ip_subnet_node parameter
for each ip_subnet as necessary; see “About Cross-Subnet Failover” (page 141) for
more information.
Editing the Configuration File 217