Managing HP Serviceguard for Linux Ninth Edition, April 2009

NOTE: The Script_Parameters section of the PACKAGE output of cmviewcl
shows the Subnet status only for the node that the package is running on. In a
cross-subnet configuration, in which the package may be able to fail over to a node on
another subnet, that other subnet is not shown (see “Cross-Subnet Configurations”
(page 32)).
Quorum Server Status
If the cluster is using a quorum server for tie-breaking services, the display shows the
server name, state and status following the entry for each node, as in the following
excerpt from the output of cmviewcl -v:
CLUSTER STATUS
example up
NODE STATUS STATE
ftsys9 up running
Quorum Server Status:
NAME STATUS STATE
lp-qs up running
...
NODE STATUS STATE
ftsys10 up running
Quorum Server Status:
NAME STATUS STATE
lp-qs up running
Status After Halting a Package
After we halt pkg2 with the cmhaltpkg command, the output of cmviewcl-v is as
follows:
CLUSTER STATUS
example up
NODE STATUS STATE
ftsys9 up running
Network_Parameters:
INTERFACE STATUS NAME
PRIMARY up eth0
PRIMARY up eth1
PACKAGE STATUS STATE AUTO_RUN NODE
pkg1 up running enabled ftsys9
Policy_Parameters:
Reviewing Cluster and Package Status 227