Metrocluster with Continuous Access XP P9000 for Linux Version B.01.00.10 Release Notes

The B.01.00.00 version of Metrocluster with Continuous Access XP P9000 for Linux supports the
following features:
• “Support for Serviceguard A.11.20.xx” (page 5)
• Support for HP XP P9000 Storage Family
• “Support for Device Group Monitor ” (page 5)
• “Support for Data Replication Storage Failover Preview” (page 5)
• “Support for Remote Command Device” (page 6)
• “Support for failover polices site_preferred and site_preferred_manual” (page 6)
• “Support for persistent reservations” (page 6)
• “Support for Device Mapper ” (page 7)
• “Support for VMWare virtual machines as Metrocluster nodes” (page 7)
Support for Serviceguard A.11.20.xx
NOTE: A.11.20.xx refers to Serviceguard version A.11.20.00 or A.11.20.10.
Metrocluster for Linux supports HP Serviceguard version A.11.20.xx. All the HP Serviceguard
configuration are also applicable to Metrocluster. All the features available with Serviceguard
A.11.20.xx are supported in a Metrocluster configuration unless explicitly stated.
IMPORTANT:
• In a Metrocluster environment, the cmeval tool cannot be used to evaluate the replication
status and any changes to the Metrocluster package parameters.
• The online reconfiguration of Metrocluster pacakge device group monitor feature parameters
is not supported.
Support for Device Group Monitor
Metrocluster with Continuous Access XP P9000 for Linux products supports Device Group Monitor
(DGM). DGM provides the capability to monitor the status of the Continuous Access device groups
configured in a Metrocluster package, from the node where the package is running.
Device Group Monitor provides the following functionalities:
• Sends a notification message upon the change in a device group status.
• Performs automatic resynchronization of the Continuous Access device group upon link
recovery.
For more information on Device Group Monitor in a Metrocluster Solution, see Building Disaster
Recovery Serviceguard Solutions Using Metrocluster with Continuous Access XP P9000 for Linux
available at http://www.hp.com/go/linux-serviceguard-docs.
Support for Data Replication Storage Failover Preview
The cmdrprev command enables you to preview the preparation process for data replication in
a Metrocluster environment and also helps you in identifying any potential problems in the data
replication environment, which if left undetected, may result in an unsuccessful Metrocluster failover.
For more information on using the cmdrprev command in your Metrocluster environment, see
Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access XP
P9000 for Linux available at http://www.hp.com/go/linux-serviceguard-docs.
NOTE: You must install the Metrocluster Add-ons for Linux RPM to use the cmdrprev command.
Features Supported in B.01.00.00 5