Smart Array 5300 Controller User Guide

Upgrading and Replacing Options
To remove the RAID ADG Enabler Module:
Press the innermost plastic clip under the controller board towards the other clip (1),
and push the module out of the board (2).
1
2
Figure 8-16: Removing the RAID ADG Enabler Module
To install the module on the new controller board:
1. Check that the array accelerator on the new controller board has at least 64 MB
of read/write cache.
2. Hold the module at an angle and insert the rear end of the module into the
appropriate slot (1).
HP Smart Array 5300 Controller User Guide 8-15
HP CONFIDENTIAL
Writer: Kimberly Koch File Name: i-ch8 upgrading and replacing options.doc
Codename: SilverHammer Part Number: 135606-006 Last Saved On: 3/13/03 1:59 PM