Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access XP P9000 for Linux B.01.00.00

/dev/sda /dev/sdf
#/************************* HORCM_DEV *************************************/
#
# The HORCM_DEV parameter is used to define the addresses of the physical
# volumes corresponding to the paired logical volume names. every group
# name is a unique name used by the hosts which will access the volumes.
#
# The group and paired logical volume names defined here must be the same for
# all other (remote) hosts that will access this device group.
# The hardware SCSI bus, SCSI-ID, and LUNs for the device groups do not need
# to be the same on remote hosts.
#
# <dev_group>
# This parameter is used to define the device group name for paired logical
# volumes. The device group name is used by all Raid Manager commands for
# accessing these paired logical volumes.
# <dev_name>
# This parameter is used to define the names of the paired logical volumes
# in the device group.
# <port#>
# This parameter is used to designate the RAID port number associated with the
# physical volume.
# <TargetID>
# This parameter is used to designate the SCSI/Fibre target ID.
# <LUN#>
# This parameter is used to designate the SCSI/Fibre logical unit number (LU#)
HORCM_DEV
#dev_group dev_name port# TargetID LUN#
pkgA pkgA_index CL1-E 0 1
pkgA pkgA_tables CL1-E 0 2
pkgA pkgA_logs CL1-E 0 3
pkgB pkgB_d1 CL1-E 0 4
pkgC pkgC_d1 CL1-E 0 5
pkgD pkgD_d1 CL1-E 0 2
#/************************* HORCM_INST ************************************/
#
# This parameter is used to define the network address (IP address or host
# name) of the remote hosts which can provide the remote Raid Manager access
# for every of the device group secondary volumes.
# The remote Raid Manager instances are required to get status or provide
# control of the remote devices in the device group. All remote hosts
# must be defined here, so that the failure of one remote host will prevent
# obtaining status.
#
# <dev_group>
# This is the same device group names as defined in dev_group of HORC_DEV.
# <ip_address>
# This parameter is used to define the network address of the remote hosts
# with Raid Manager access to the device group. This can be either an
# IP address or a host name.
# <service>
# This parameter is used to specify the port name assigned to the Raid
# Manager instance, which must be registered in /etc/services. If this is
# a port number rather than a port name, then the port number is used.
HORCM_INST
#dev_group ip_address service
pkgA ftsys1a horcm0
pkgA ftsys2a horcm0
pkgB ftsys1a horcm0
pkgB ftsys2a horcm0
pkgC ftsys1a horcm0
pkgC ftsys2a horcm0
pkgD ftsys1a horcm0
pkgD ftsys2a horcm0
Sample Raid Manager configuration file 65