Metrocluster with Continuous Access XP P9000 for Linux Version B.01.00.00 Release Notes

Mode 449 for Continuous Access Journal Operations
Metrocluster supports Mode 449, which is set to the same value for P9500, XP20000, and XP24000
disk arrays. The value of either “ON” or “OFF” should set for P9500, XP20000, and XP24000
disk arrays. Metrocluster does not support a mixed setting of Mode 449. For example, if Mode
499=ON for the primary array and Mode 449=OFF for the secondary array, this configuration
would not be supported. Contact your HP representative to verify and update the Mode 449
settings.
Installing Metrocluster with Continuous Access XP P9000 for Linux
Metrocluster with Continuous Access XP P9000 for Linux can be installed while the system is running
in multi-user mode.
1. Install therpm to install Metrocluster with Continuous Access XP P9000 for Linux product.
For Red Hat:
# rpm –i
serviceguard-metrocluster-caxpp9000-B.01.00.00.00-0.rhel5.x86_64.rpm
(RHEL 5.x only)
# rpm –i
serviceguard-metrocluster-caxpp9000-B.01.00.00.00-0.rhel6.x86_64.rpm
(RHEL 6.x only)
For SLES:
# rpm –i
serviceguard-metrocluster-caxpp9000-B.01.00.00.00-0.sles11.x86_64.rpm
The software resides in the following directories:
For Red Hat:
/usr/local/cmcluster/bin
/usr/local/cmcluster/conf
For SLES:
/opt/cmcluster/bin
/opt/cmcluster/conf
2. Install therpm to install Metrocluster Add-ons for Linux.
For Red Hat:
# rpm –i
serviceguard-metrocluster-addons-B.01.00.00.00-0.rhel5.x86_64.rpm
(RHEL 5.x only)
# rpm –i
serviceguard-metrocluster-addons-B.01.00.00.00-0.rhel6.x86_64.rpm
(RHEL 6.x only)
For SLES:
# rpm –i
serviceguard-metrocluster-addons-B.01.00.00.00.sles11.x86_64.rpm
The software resides in the following directories:
For Red Hat:
/usr/local/cmcluster/bin
/usr/local/cmcluster/doc/man
For SLES:
/opt/cmcluster/bin
10 Metrocluster with Continuous Access XP P9000 for Linux Version B.01.00.00 Release Notes