Metrocluster with Continuous Access XP Version A.11.00 Release Notes, August 2010 (B8109-90027)

HP StorageWorks Disk Array Requirements
HP-UX 11i v2 or HP-UX 11i v3 using Two Data Center Configuration:
HP StorageWorks Disk Array XP20000/XP24000 with the following:
Microcode version 60-04-04-00/10 or later
HP StorageWorks Disk Array XP512/XP48 with the following:
Microcode version 01-19-99-00/02 or later
HP StorageWorks Disk Array XP1024/XP128 with the following:
Microcode version 21-14-40-00/00 or later
HP StorageWorks Disk Array XP10000/XP12000 with the following:
Microcode version 50-09-78-00/00 or later
HP-UX 11i v2 or HP-UX 11i v3 using Three Data Center (3DC) Configuration:
HP StorageWorks Disk Array XP20000/XP24000 with the following:
Microcode version 60-04-04-00/10 or later
HP StorageWorks Disk Array XP10000 and XP12000 with the following:
Microcode version 50-09-78-00/00 or later
RCP/LCP Continuous Access boards must be installed and used in pairs for redundancy.
Multiple ports on a single board may be used to improve performance, or to connect
to different XP series remote frames. There must always be at least four Continuous
Access links, two in each direction. The XP series cannot use a Continuous Access link
bi-directionally. Therefore, it is required to configure one pair to go in one direction
and another pair to go in the other direction. Otherwise, it is not possible to fail over
and fail back without a major Continuous Access link reconfiguration.
These release notes state the minimum version requirements for Microcode with the
Metrocluster product. Contact your HP Storage Representative to ensure you have
up-to-date and correct versions of Microcode for your HP StorageWorks Disk Array
XP environment.
Host System Requirements
HP-UX 11i v2 and HP-UX 11i v3:
HP Integrity servers or HP 9000 servers
HP Software Requirements
The following lists the Serviceguard and HP-UX versions required for running
Metrocluster with Continuous Access XP.
HP-UX 11i v2 and HP-UX 11i v3:
Compatibility Information and Installation Requirements 11