HP Serviceguard Storage Management Suite A.04.00 Release Notes

NOTE: You might benefit from using Dynamic Root Disk (DRD) utilities to perform your
uprade, if your upgrade is supported with DRD. See “Using Dynamic Root Disk Utilities (DRD)
to upgrade to SG SMS A.04.00” (page 24) for more information.
NOTE: Table 6 (page 22), is current as of the publication date of these Release Notes. The
most recent information on supported bundle upgrade paths is available in the HP Serviceguard
Storage Management Suite Bundles - Supported Upgrade Paths Matrix available at:
www.hp.com/go/hpux-serviceguard-docs → HP Serviceguard Storage Management Suite
A.04.00
• Upgrade paths that are not listed in Table 6 will require an uninstall of the SG SMS bundle,
before a different SG SMS bundle can be installed and configured.
Table 6 Supported SG SMS Bundle Upgrade Paths - HP-UX 11i v3
A.04.00A.03.01A.03.00A.02.01 or
A.02.01.01
SG SMS Version
11i v311i v311i v311i v3HP-UX Version
A.11.20A.11.20A.11.19A.11.19Serviceguard
Version
5.1 SP15.0.15.0.15.0Veritas SF Version
T2774EBR →T2774DBR →T2774DBR →T2774CBSG Storage Mgmt
Oracle Prem
T2777EBO →T2777DBR →T2777DBO →T2777CBSG Cluster File
System RAC
T8684EBR →T8684DBR →T8684DBR →T8684CBHAOE w/ SG SMS
Oracle Prem
T8687EBO →T8687DBR →T8687DBO →T8687CBHAOE w/ SG SMS
CFS RAC
T8694EBR →T8694DBR →T8694DBR →T8694CBDCOE w/ SG SMS
Oracle Prem
T8697EBO →T8697DBR →T8697DBO →T8697CBDCOE w/ SG SMS
CFS RAC
NOTE: If a newly installed bundle includes the same version of a product that was previously
installed and patched, the patches may need to be installed again.
NOTE: If there is a cluster configured on a node, the swremove command will not let you remove
SG SMS from that node. You must halt the node, remove the node from the cluster, and then use
swremove to remove SG SMS.
NOTE: The procedure for rolling or offline upgrades of SG SMS HAOE or DCOE bundles requires
additional steps. See “HP-UX Operating Environment Upgrade Limitations” (page 43) for more
information.
Disabling Cluster Auto-Start on Reboot
Before attempting a SG SMS bundle installation or upgrade, you must disable AUTOSTART_CMCLD.
To disable AUTOSTART_CMCLD on all cluster nodes, access the/etc/rc.cofig.d/cmcluster
file and set AUTOSTART_CMCLD to 0, (AUTOSTART_CMCLD=0).
To re-enable Automatic startup (AUTOSTART_CMCLD) after completing your SG SMS bundle
installation or upgrade, set the flag AUTOSTART_CMCLD to 1 in the /etc/rc.config.d/
cmcluster file (AUTOSTART_CMCLD=1)
22 HP Serviceguard Storage Management Suite Version A.04.00 for HP-UX 11i v3 Release Notes