HP StorageWorks 2000 Modular Smart Array Reference Guide (481599-003, August 2008)

158 HP StorageWorks 2000 Family Modular Smart Array reference guide • August 2008
LAN Information
You can view Ethernet and IP information for each controller, and information
about the system. To change the LAN settings, see “Configuring Ethernet
Management Ports” on page 48. To change the system information, see “Setting
System Information” on page 37.
To view LAN information:
● Select Monitor > Status > Advanced Settings > LAN Information.
The following information is displayed:
■ Ethernet Address – Each controller’s unique Media Access Controller (MAC)
hardware address, also known as the physical address.
■ Ethernet Link – Each controller’s Ethernet link status: Active (operational) or
Link Down (not operational).
■ IP Address – Each controller’s Ethernet management port IP address. The default
is 10.0.0.2 for controller A and 10.0.0.3 for controller B.
■ IP Subnet Mask – Each controller’s IP subnet mask. The default is
255.255.255.0.
■ IP Gateway – Each controller’s gateway IP address. The default is 10.0.0.1.
■ Source For IP Address – Manual or DHCP.
■ Telnet Timeout – The number of idle minutes before the Telnet session times out.
The allowed values are 0–255 minutes, where 0 means no timeout. The default is
60 minutes.
■ System Name – Name of the system as seen by other systems on the network.
The default is Uninitialized Name.
■ System Contact – Name of a contact person responsible for the system. The
default is Uninitialized Contact.
■ System Location – Location of the system. The default is Uninitialized Location.
■ System Information – Additional information about the system. The default is
Uninitialized Info.