HP StorageWorks 2000 Modular Smart Array Reference Guide (481599-003, August 2008)

Appendix E Event Codes 297
265 Informational Port bypass circuits currently use the
service port, which may limit the link
speed or interconnect mode support.
Perform a system-level shutdown
and restart. Note that this will
cause all data to be unavailable for
about 1 minute.
266 Informational A copy operation for the specified
master volume has been aborted.
268 Informational A background copy operation for the
specified master volume completed.
269 Informational A partner firmware update operation
has started. This operation is used to
copy firmware from one controller to
the other to bring both controllers up
to the same version of firmware.
270 Warning There is a problem reading or writing
the persistent IP data from the FRU-
ID SEEPROM, or if invalid data is
read from the FRU-ID SEEPROM.
Check the IP settings (including
iSCSI host channel IP data for an
iSCSI system), and update them if
they are incorrect.
271 Informational System could not get a valid serial
number from the controller’s FRU-ID
SEEPROM, either because it couldn't
read the FRU-ID data, or because the
data on it isn't valid or hasn't been
programmed. Therefore, the MAC
address is derived by using the
controller’s serial number from flash.
This event is only logged one time
during bootup.
272 Informational The snap pool is being expanded.
273 Informational Fault isolation has been enabled or
disabled for the specified enclosure
and controller within that enclosure.
274 Informational A phy has been disabled.
275 Informational A phy has been enabled.
TABLE E-1 Event Descriptions and Recommended Actions (Continued)
Event
Code Event Type Description Recommended Action