HP StorageWorks 2000 Modular Smart Array Reference Guide (481599-003, August 2008)

Chapter 2 Configuring Your System for the First Time 31
Configuring User Access
By default, the system provides three users that can access the system. In addition to
these users, which you can modify, you can add 10 other users (13 maximum). The
user configuration function enables you to define user roles by setting specific
access privileges. For each user you can set a password and enable or disable access
to the following system interfaces: WBI (SMU), CLI (command-line interface), and
FTP.
The default users are configured with the usernames, access levels, user types, and
default passwords shown in the following table.
Note – To secure the storage system, change each Manage user’s password.
User Roles
Each user role is defined by an access level of either Monitor or Manage:
■ Monitor – Enables access to functions on the Monitor menu.
■ Manage – Enables access to functions on the Monitor and Manage menus.
Up to five Monitor users and only one Manage user can be logged in to each
controller. SMU distinguishes users by their IP addresses. If you log in to SMU
using multiple browser instances on the same management host, SMU considers all
instances as a single user; actions you take in one instance are reflected in the other
instances on the same host.
Note – If you are a Monitor user and you attempt to change a Manage user setting,
SMU prompts you to log in as a Manage user. If you enter a correct Manage
username and password, you are logged out of your Monitor session.
Table 2-1 Default User Configuration
Username Access Level User Type Password
monitor Monitor Standard !monitor
manage Manage Standard !manage
ftp Manage Standard flash