HP StorageWorks 2012sa Modular Smart Array user (488320-004, March 2013)
Table Of Contents
- Contents
- About This Guide
- 1
- System Components
- 2
- Installing and Cabling Enclosures
- 3
- Connecting Hosts
- 4
- Configuring a System for the First Time
- 5
- Troubleshooting
- Fault Isolation Methodology
- Correcting Enclosure IDs
- Using System LEDs to Diagnose Problems
- Is the front panel Fault ID amber?
- Is the controller back panel OK LED off?
- Is the controller back panel Fault/Service Required LED amber?
- Are both drive module LEDs, Online/Activity, and Fault/UID LEDs off?
- Is the drive module Fault/UID LED blinking amber?
- Is a connected port’s Host Link Status LED off?
- Is a connected port’s Expansion Port status LED off?
- Is a connected port’s Ethernet link status LED off?
- Is the power-and-cooling module AC Power Good LED off?
- Is the power-and-cooling module DC Voltage/Fan Fault/Service Required LED amber?
- Is the drive enclosure back panel OK LED off?
- Is the drive enclosure Fault/Service Required LED amber?
- Isolating a Host-Side Connection Fault
- Isolating a Controller Module Expansion Port Connection Fault
- Resolving Voltage and Temperature Warnings
- A
- Environmental Requirements and Specifications
- B
- Regulatory Compliance and Safety
- Index
25
CHAPTER
2
Installing and Cabling Enclosures
This chapter describes how to install and cable enclosures. It contains the following
sections:
■ “Site Planning” on page 25
■ “Required Tools” on page 25
■ “Safety Precautions” on page 26
■ “Installation Checklist” on page 27
■ “Installing Enclosures Into a Rack” on page 28
■ “Attaching the Ear Caps” on page 32
■ “Connecting Controller and Drive Enclosures” on page 33
■ “Connecting AC Power” on page 36
■ “Testing the Enclosure Connections” on page 37
■ “Obtaining IP Values for Your Storage System” on page 38
■ “Correcting Enclosure IDs” on page 38
Site Planning
Make sure that the installation site adheres to all requirements and specifications as
described in “Environmental Requirements and Specifications” on page 71.
Required Tools
The installation procedures in this chapter require the following tools:
■ #2 Phillips screwdriver
■ Antistatic protection devices