HP StorageWorks 2012sa Modular Smart Array user (488320-004, March 2013)
Table Of Contents
- Contents
- About This Guide
- 1
- System Components
- 2
- Installing and Cabling Enclosures
- 3
- Connecting Hosts
- 4
- Configuring a System for the First Time
- 5
- Troubleshooting
- Fault Isolation Methodology
- Correcting Enclosure IDs
- Using System LEDs to Diagnose Problems
- Is the front panel Fault ID amber?
- Is the controller back panel OK LED off?
- Is the controller back panel Fault/Service Required LED amber?
- Are both drive module LEDs, Online/Activity, and Fault/UID LEDs off?
- Is the drive module Fault/UID LED blinking amber?
- Is a connected port’s Host Link Status LED off?
- Is a connected port’s Expansion Port status LED off?
- Is a connected port’s Ethernet link status LED off?
- Is the power-and-cooling module AC Power Good LED off?
- Is the power-and-cooling module DC Voltage/Fan Fault/Service Required LED amber?
- Is the drive enclosure back panel OK LED off?
- Is the drive enclosure Fault/Service Required LED amber?
- Isolating a Host-Side Connection Fault
- Isolating a Controller Module Expansion Port Connection Fault
- Resolving Voltage and Temperature Warnings
- A
- Environmental Requirements and Specifications
- B
- Regulatory Compliance and Safety
- Index
Appendix A Environmental Requirements and Specifications 73
Electrical Guidelines
■ These enclosures work with single-phase power systems having an earth ground
connection. To reduce the risk of electric shock, do not plug an enclosure into
any other type of power system. Contact your facilities manager or a qualified
electrician if you are not sure what type of power is supplied to your building.
■ Enclosures are shipped with a grounding-type (three-wire) power cord. To reduce
the risk of electric shock, always plug the cord into a grounded power outlet.
■ Do not use household extension cords with the enclosures. Not all power cords
have the same current ratings. Household extension cords do not have overload
protection and are not meant for use with computer systems.
Ventilation Requirements
Refer to “Environmental Requirements” on page 75 for detailed environmental
requirements.
■ Do not block or cover ventilation openings at the front and rear of an enclosure.
Never place an enclosure near a radiator or heating vent. Failure to follow these
guidelines can cause overheating and affect the reliability and warranty of your
enclosure.
■ Leave a minimum of 6 inches (15 cm) at the front and back of each enclosure to
ensure adequate airflow for cooling. No cooling clearance is required on the
sides, top, or bottom of enclosures.
■ Leave enough space in front and in back of an enclosure to allow access to
enclosure components for servicing. Removing a component requires a clearance
of at least 15 inches (37 cm) in front of and behind the enclosure.
Cabling Requirements
■ Keep power and interface cables clear of foot traffic. Route cables in locations
that protect the cables from damage.
■ Route interface cables away from motors and other sources of magnetic or radio
frequency interference.
■ Stay within the cable length limitations.