HP StorageWorks 2012sa Modular Smart Array user (488320-004, March 2013)
Table Of Contents
- Contents
- About This Guide
- 1
- System Components
- 2
- Installing and Cabling Enclosures
- 3
- Connecting Hosts
- 4
- Configuring a System for the First Time
- 5
- Troubleshooting
- Fault Isolation Methodology
- Correcting Enclosure IDs
- Using System LEDs to Diagnose Problems
- Is the front panel Fault ID amber?
- Is the controller back panel OK LED off?
- Is the controller back panel Fault/Service Required LED amber?
- Are both drive module LEDs, Online/Activity, and Fault/UID LEDs off?
- Is the drive module Fault/UID LED blinking amber?
- Is a connected port’s Host Link Status LED off?
- Is a connected port’s Expansion Port status LED off?
- Is a connected port’s Ethernet link status LED off?
- Is the power-and-cooling module AC Power Good LED off?
- Is the power-and-cooling module DC Voltage/Fan Fault/Service Required LED amber?
- Is the drive enclosure back panel OK LED off?
- Is the drive enclosure Fault/Service Required LED amber?
- Isolating a Host-Side Connection Fault
- Isolating a Controller Module Expansion Port Connection Fault
- Resolving Voltage and Temperature Warnings
- A
- Environmental Requirements and Specifications
- B
- Regulatory Compliance and Safety
- Index
97
Index
A
accessing
SMU,46
the CLI,42
accumulators,84
Avis Canadien, regulatory compliance
notice,81
B
batteries
recycling or disposal,84
replacement
notice,84
Taiwan EPA recycling and disposal,84
boot straps, using,86
BSMI, regulatory compliance notice,82
C
cables
FCC compliance statement,74, 79
shielded,74, 79
cabling
routing requirements,73
Canada, regulatory compliance notice,81
certification and classification information, laser,81
Class A equipment, Canadian compliance statement,81
Class B equipment, Canadian compliance statement,82
clearance requirements
service,73
ventilation,73
CLI, See command-line interface
command-line interface
about,12
accessing,42
using to set controller IP addresses,42
configuring
direct attach configurations,40
SMU,46
storage, first time,41
connecting
AC power,36
controller and drive enclosures,33
controller enclosures to data hosts,40
serial cable to set IP address,42
to remote management hosts,40
using reverse cabling,33
console requirement,74
controller enclosures
components,13
connecting to data hosts,40
connecting to multiple drive enclosures,33
connecting to remote management hosts,40
controller modules
LEDs
cache status, 18, 19
Ethernet activity,20
Ethernet link status,19
expansion port status,20
Fault/Service Required,18
host activity,19
host link status,17
OK,18
OK to Remove,18
Unit Locator,18
location,16
ports
CLI,16
Ethernet,16
expansion,16
host,16
service,16
cooling element
fan sensor descriptions
,67
cord. See power cord
current rating,85