HP StorageWorks Modular Smart Array 1510i 2-Port Ethernet iSCSI module replacement instructions (February 2006)

Page 2

Replacing the module

Step 1: Remove the failed module

Cease access to the module and disconnect the cable(s).

Then, lift the port-colored latch (1) on the failed module and pull the

module straight out of the chassis (2).

Step 2: Install the replacement module

Slide the replacement module into the chassis, until the module

clicks into place. Then, reconnect the cables.

Verifying module status

After installing the replacement Ethernet iSCSI module, verify that:

• The status LED at the top of the module is solid green.

• No new error messages are displayed on the LCD panel.

NOTE: Unread error log messages can cause the fault LED to

light. Delete all resolved error messages.

Returning the failed module

Follow the instructions shipped with the replacement.

Additional information

See the HP StorageWorks MSA1510i maintenance and service

guide or other MSA1510i-related documents on the MSA1510i

web site: http://h18006.www1.hp.com/products/storageworks/msa1510i.

15177

15178