Brocade Web Tools Administrator's Guide - Supporting Fabric OS v7.0.0 (53-1002152-01, March 2012)

100 Web Tools Adminstrator’s Guide
53-1002152-01
Viewing trunk group information
7
To disable trunking on a port, or to re-enable trunking if it has been disabled, perform the following
steps.
1. Select a port in the Switch View to open the Port Admin window.
2. Select the FC Ports tab.
3. From the tree on the left, select the switch name or slot name.
4. From the table, select the port that you want to trunk.
You can select multiple ports from the table. You cannot select multiple ports from the tree.
5. Click the Show Advanced Mode button on Ports Admin.
Click either the Trunking Enable or Trunking Disable button.
If the button is unavailable, then the selected port is already in that state.
6. 6. Click Yes in the confirmation dialog box.
Admin Domain considerations
You can only enable and disable trunking for a port when the current Admin Domain owns the
switch. You can log in to a switch that is not in your Admin Domain, but most of the functionality is
unavailable. F_Port trunking should not be configured in physical fabric mode.
Viewing trunk group information
Use the Trunking tab on the Switch Administration window to view trunk group information.
FIGURE 19 Trunking tab
The following trunking attributes can be displayed from the Switch Admin view:
• Trunk port state, either master or slave.
• Trunk master port
• Trunk index (applies only to F_Port trunking).
• Trunk type