Manualshelf

Brocade Web Tools Administrator's Guide - Supporting Fabric OS v7.0.0 (53-1002152-01, March 2012)

ManualsBrandsHP ManualsComputer AccessoriesHP SN8000B 16Gb 32-port Fibre Channel Blade
261262263264265266267268269270
Web Tools Adminstrator’s Guide 237
53-1002152-01
Configuring FCoE login groups
18
NOTE
If you want to modify any converged interface as either native or non-native, you must first
remove that particular member from that VLAN and then re-add it to the same VLAN.
6. Under the Selection List, click the plus sign (+) next to the Interface and LAG folders, and select
individual interfaces and LAGs you want to associate with the VLAN ID.
7. Cl ick Add to move the interfaces or LAGs to the Selected List.
Note the reminder that interfaces must be configured as L2, and that the interfaces or LAGs
must be in Trunk mode to be associated with multiple VLANs, Access mode interfaces can be
associated with only one VLAN, and the Converged mode interface can be Native in one VLAN
and it could be non-native type in more than one VLAN.
8. Click OK.
9. Repeat the procedure for additional VLANs.
10. To edit VLAN, select the detail from the table in the VLAN tab and click Edit.
NOTE
The FCoE check box is selected by default for FCoE VLAN. The FCoE check box is read-only, you
must use the CLI to make any changes to the FCoE VLAN.
11. Click OK to enable FCoE. Clear the check box to disable FCoE.
Configuring FCoE login groups
FCoE login groups control which FCoE devices are allowed to log in to a switch or fabric.
The FCoE Ports window is used for configuring the FCoE ports on a switch.
To configure an FCoE login group, perform the following steps.
1. Select the DCB tab on the Switch Administration panel.
2. Select the FCoE Login Group tab.
3. Click New.
The New Login Group dialog box displays.
4. Enter a name for the login group in the Login Group Name field.
5. Select the switch WWN.
The choices are:
• Self — WWN of your current switch
• Other Switch WWN
If you choose Other Switch WWN, you must enter the WWN of that switch in the provided field.
6. Under Login Member Configuration, select either Allow All Members or Allow Specific Member.
• If you select Allow All Members, all devices attached to FCoE ports are allowed to log in to
the switch.