Brocade Web Tools Administrator's Guide - Supporting Fabric OS v7.0.0 (53-1002152-01, March 2012)

238 Web Tools Adminstrator’s Guide
53-1002152-01
Displaying FCoE port information
18
• If you select Allow Specific Member, you can control which devices can log in, using
Member Type, Member PWWN/MAC, and the Add and Remove buttons, as described
below.
a. Select Model2 as Member Type.
a. Enter the port WWN in hexadecimal format in the Member PWWN/MAC field, and click
Add.
The WWN displays under Allowed Login Members. If you decide a member should not be
on the list, highlight the entry and click Remove.
7. Cl ick OK.
Displaying FCoE port information
There are 24 internal FCoE Ports that bridge FC and Ethernet traffic. You can view FCoE port
information from the Port Administration panel.
To display FCoE port information, perform the following steps.
1. Select the FCoE Ports tab on the Port Administration panel.
The initial view displays a summary of all FCoE ports on the switch (Figure 46).
FIGURE 46 FCoE Ports tab, Port Administration panel
2. To view information for a specific port, select the trunk in the FC
0E Ports Explorer or select the
port in the FCoE Port Configuration and Management table and click View Details.
Port information displays in three tabs. The General tab is pre-selected.
The Connected Devices tab displays information about devices connected to the switch
(Figure 46). Six columns of information are displayed:
• Device WWN displays the WWN of the connected device.
• Device MAC displays the MAC address of the connected device.