Brocade Web Tools Administrator's Guide - Supporting Fabric OS v7.0.0 (53-1002152-01, March 2012)

Web Tools Adminstrator’s Guide 33
53-1002152-01
Configuring IP and subnet mask information
3
Opening the Switch Administration window
Most of the management procedures in this chapter are performed from the Switch Administration
window.
To open the Switch Administration window, perform the following steps.
1. Select Tasks > Manage > Switch Admin.
The Switch Administration dialog box displays in basic mode, as shown in Figure 8 on page 32.
The basic mode displays the “basic” tabs and options.
2. Click Show Advanced Mode to see all the available tabs and options.
Configuring IP and subnet mask information
Before proceeding, collect all the information you need to configure the Ethernet IP interface. This
includes the subnet mask, gateway IP address, or IPFC, and subnet mask for your system. When
you configure or change the Ethernet IP, subnet mask, gateway IP, or IPFC, and subnet mask from
Web Tools, there is a normal loss of network connection to the switch. Close all current windows
and restart Web Tools with the new IP address.
NOTE
The IPFC address is specific for each logical switch. The IPFC address is set to FC0 for switches that
do not support Virtual Fabrics.
To configure the IP and subnet mask information, perform the following steps.
1. Select the Network tab.
2. In the appropriate IP address section, enter the IP address you want to use for the IP interface.
Use the IPv4 Address section or the IPv6 Address section to specify IP addresses.
3. In the IPv4 Address section:
• In the Ethernet IP field, enter the Ethernet IP address.
• In the Ethernet Mask field, enter the Ethernet mask address.
• In the GateWay IP address field, enter the gateway IP address.
4. In the IPv6 Address section, in the Ethernet IPv6 field, enter the Ethernet IP address.
5. You can also enable automatic configuration of IPv6 addresses by selecting Enable IPV6 Auto
Configuration.
The automatically generated IPv6 addresses are displayed under Auto Configured IPV6
Addresses. Eight auto-configured addresses are created per switch, and up to 24 for a DCX, or
DCX-4S chassis (eight per chassis, and eight per each installed CP).
Configuring Netstat Auto Refresh
The Netstat Performance window displays the details about Ethernet management port statistics
like the Interface, MTU, Met, RX-OK, RX-ERR, RX-DRP, RX-OVR, TX-OK, TX-ERR, TX-DRP, TX-OVR, and
Flag.