HP Storage Essentials Storage Resource Management Report Optimizer Software 6.0 Installation Guide (October 2008)

Installing and Configuring SRM Report Optimizer on Microsoft Windows6
3. If the box next to Internet Explorer Enhanced Security Configuration does not contain a check
mark, then the feature is already disabled and no additional steps are required. If the box does
contain a check mark, continue to the next step.
4. Click the box next to Internet Explorer Enhanced Security Configuration to remove the check
mark.
5. Click Next. Enhanced Security is disabled.
Increasing the memory heap size value
Increasing the memory heap size value size will prevent potential error messages. To increase the
memory heap size value:
1. Click Start > Run. The Run dialog box appears.
2. Enter regedit in the Open text field.
3. Click OK. The Registry Editor displays.
4. Navigate to HKEY_LOCAL_MACHINE/SYSTEM/CurrentControlSet/Control/Session
Manager/Subsystems.
5. Right-click the Windows key and select Modify.
6. Edit the SharedSection value from 1024,3072,512 to 1024,3072,1024.
7. Navigate to HKEY_LOCAL_MACHINE\SOFTWARE\Business Objects\Suite
11.5\default\WebIntelligence\Server\Admin\SwapTimeOut.
8. Edit this value to 1500 seconds. Alternatively, set this to a value higher than the Web Intelligence
Report Server connection time out value found in the Central Management Console. This value is
written in minutes. The default value is 20.
9. Close the Registry Editor.
10. Restart the Web Intelligence Report Server for the changes to take effect.
Configuring drill-down options
The drill-down options must be properly configured to synchronize graphs with drill-down reports. To
configure the drill-down options:
1. Log on to InfoView.
a. User a web browser to go to the following URL:
http://<fqdn_or_ip_address_of_Report_Server>:8080/businessobjects/
enterprise115/desktoplaunch/InfoView/logon/logon.do
NOTE: If you changed the port number during installation, enter the selected port number
instead of 8080.
b. Log on with a valid username and password.
2. In the upper-right corner of your browser, click the Preferences button.
3. Click the Web Intelligence Document tab.
4. In the General Drill Options section, click the Synchronize drill on report blocks checkbox.
5. Click Apply.