HP Storage Essentials V5.00.01 installation guide (T4283-96011, January 2006)

Storage Essentials 5.00.01 Installation Guide 131
HP SNIA Adapters AXXXXA comes from fileset FC-FCD, FC-TACHYON-TL. Unless separated
purposely during installing the operating system, filesets are there by default. To view the location of
the library, enter the following at the command prompt:
# more /etc/hba.conf
The following is displayed:
com.hp.fcms32 /usr/lib/libhbaapihp.sl #32 bit lib names end in '32'
com.hp.fcms64 /usr/lib/pa20_64/libhbaapihp.sl #64 bit lib names end in '64'
• com.hp.fcd32 /usr/lib/libhbaapifcd.sl
• com.hp.fcd64 /usr/lib/pa20_64/libhbaapifcd.sl
Installing the CIM Extension
Keep in mind the following:
• The instructions in this section apply if you are doing a local installation of the CIM Extension, as
compared to a scripted or push installation. If you want to perform a scripted or push installation
of the CIM Extension, first install the CIM Extension locally by using the instructions in this
section. Then, perform the scripted or push installation. The instructions in this section only need
to be performed once if you are doing a scripted or push installation. Contact customer support
for information about performing a scripted or push installation.
• You must install the CIM Extension for HP-UX to the default directory.
To install the CIM Extension using CLI:
1. Login as root.
2. Place CIM Extension CD-ROM into the CD-ROM on HP-UX server.
3. Create the /cdrom directory on HP-UX host by entering the following at the command prompt:
# mkdir /cdrom
4. Mount the CIM Extension CD-ROM by enter the following at the command prompt:
# mount /dev/dsk/c#t#d# /cdrom
where c, t and d numbers correspond to CD-ROM device numbers
To find out c#t#d# of your CD-ROM, run “ioscan –fnC disk” command on the HP-UX host.
5. To install the CIM Extension, enter the following at the command prompt:
# swinstall -s /cdrom/HPUX/APPQcime.depot APPQcime
The installation is complete when you are told the "analysis and execution
succeeded."
6. Eject/unload the CD-ROM by unmounting the CD-ROM and pressing eject/unload button on the
CD-ROM drive:
# umount /cdrom
where /cdrom is the name of the directory where you mounted the CD-ROM
7. Press the Eject button on the CD-ROM drive to take the CD out of the CD-ROM drive.
The CIM Extension for HP-UX starts automatically at boot time by using /sbin/rc2.d scripts.
The CIM Extension uses port 4673 when it starts automatically after a reboot. Type the following
at the command prompt to find the status of the CIM Extension: ./status