HP Storage Essentials V5.00.01 installation guide (T4283-96011, January 2006)

Storage Essentials 5.00.01 Installation Guide 189
Driver Information for Verifying QLogic Adapters
This section provides information for verifying QLogic adapters.
If you have QLogic Adapters:
When you install the SNIA HBA, it either came with the driver or SANsurfer, the registry setting is
most likely in the following location, which varies by release:
HKEY_LOCAL_MACHINE\SOFTWARE\SNIA\HBA\QL2XXX
Newer drivers points to C:\WINNT\system32\ql2xhai2.dll, but they also have system32\qlsdm.dll
available. Earlier drivers points to C:\WINNT\System32\qlsdm.dll
Driver Information for Verifying AMCC/JNI Adapters
The SNIA HBA comes from JNI SNIA 2.0. The SNIA Library is in a separate package without the
drivers. The registry setting is the following:
HKEY_LOCAL_MACHINE\SOFTWARE\SNIA\HBA\JNI
The SNIA Library can be found in the following location:
C:\Program Files\JNI\JNIsnia\Jni\JniHbaLib.dll
Installation Steps
Keep in mind the following:
• If the installation fails with the message it cannot detect any supported HBAs and Emulex HBAs
are installed on the host, install the full HBAnywhere package. Contact Emulex at
http://www.emulex.com for more information on how to obtain full HBAnywhere package.
• You must have administrator privileges to install this software.
• Make sure other computers, including the management server, are not requesting the WMI
service from the host during installation.
• Make sure no other programs are running when you install the CIM Extension.
• On Microsoft Windows 2003 servers “Explorer Enhanced Security Settings” is enabled by
default. If this setting is enabled, the “Authenticode signature not found” message is displayed
during installation. Ignore the message or disabled the “Explorer Enhanced Security Settings”.
Perform the following steps:
1. Insert the CD-ROM for the CIM Extensions, go to the Windows directory and then double-click
InstallCIMExtensions.exe.
2. If you are asked if you want to install the product, click Yes.
3. When you see the introduction screen, click Next.
4. When you are asked for an installation directory, you can select the default or choose your own.
To choose your own directory, click the Choose button. You can always display the default
directory by clicking the Restore Default Folder button. When you are done, click Next.
5. Read the important notes, such as installing the CIM Extension on your system will stop any
service that depends on the Windows WMI service. An example is the Microsoft Exchange