HP Storage Essentials V5.00.01 installation guide (T4283-96011, January 2006)

Installing the CIM Extension for HP Tru64 UNIX162
You can tell the port is in use by entering the following at the command prompt:
netstat -a | grep 1234
The management server assumes the CIM Extension is running on port 4673. The management
server also listens on port 17000 for CIM Extensions from build 4.0. If you change the port number,
you must make the management server aware of the new port number. In the IP Address/DNS
Name field, type a colon and then the port number after the IP address or DNS name, as shown in
the following example:
192.168.1.2:1234
where
• 192.168.1.2 is the IP address of the host
• 1234 is the new port number
If you have already added the host to the discovery list, you must remove it and then re-add it. You
cannot have more than one listing of the host with different ports.
IMPORTANT: If you specify a port in the ./start command, the host can be discovered by any
account that has access to the Tru64 server.
Specifying the CIM Extension to Listen on a Specific Network Card
You can specify the CIM Extension to listen on only on a specific network interface card (NIC) by
using the “-on” command line option in the start command, for example:
./start -on 192.168.2.2
The CIM Extension listens only on the network interface card (NIC) that has the IP address
192.168.2.2. The “-on” command line option may be repeated as often as desired to direct the
CIM Extension to listen on multiple NICs, for example:
./start -on 192.168.2.2 -on 192.168.1.1
The CIM Extension listens only on the NICs that have the IP address 192.168.2.2 or 192.168.1.1.
The “-on” command line option may include a port specification. In that case, the CIM Extension
listens on the indicated port of the indicated NIC, rather than the default port, for example:
./start -on 192.168.2.2:3456
The CIM Extension listens only on the NIC that has the IP address 192.168.2.2 on port 3456. The
“-port” command line option may be used in conjunction with the “-on” option. Any “-on” arguments
that do not specify an explicit port number use the “-port” option argument as the port number, for
example:
./start -on 192.168.1.1:3456 -on 192.168.2.2 -port 1170
This command tells the CIM Extension to listen on the following ports:
• Port 3456 on the NIC with the IP address 192.168.1.1
• Port 1170 on the NIC with the IP address 192.168.2.2