HP Storage Essentials SRM 6.0 User Guide for Enterprise Edition and Standard Edition SRM Software (July 2008)

HP Storage Essentials SRM 6.0 User Guide 705

8. To modify the time-out period, set the corresponding property for your switch in the following

table to the number of millisecond you want. The default is 5000 ms. For example, to change

the time-out period to 30000 ms for a McDATA switch, you would set the

cimom.McData.Snmp.Timeout property to 30000, as shown in the following example:

cimom.McData.Snmp.Timeout=30000

1. To modify the number of retries, repeat steps 4 through 6 by copying and pasting the property

specified in the table below. Set the corresponding property for your switch in the following table

to the number of retries you want. The default is two retries. For example, to change the number

of retries to five for a McDATA switch, set the cimom.McData.Snmp.Retries properties as

shown in the following example:

cimom.McData.Snmp.Retries=5

1. When you are done, click Save.

Table 159 Time-out Properties

Switch Property

McDATA/Connectrix

discovered through SNMP

cimom.McData.Snmp.Timeout

Cisco cimom.Cisco.Snmp.Timeout

Other switches discovered

through SNMP:

• Sun StorEdge

• QLogic

cimom.snmp.switch.timeout

Table 160 Retry Properties