Manualshelf

HP Storage Essentials V5.1 Installation Guide Second Edition (Linux Release) (T4283-96055, November 2006)

ManualsBrandsHP ManualsSoftwareHP Storage Essentials Storage Resource Management Backup Mgr 1 TB Tier-2 LTU
211212213214215216217218219220
Installing the CIM Extension for OpenVMS194
9. Run the installation script by entering the following command.
$ @OVMSINST
10.Press Enter when prompted for confirmation by the PCS as shown in the example below:
**********
The following product has been selected:
HP AXPVMS APPQCIME V5.0 Layered Product
Do you want to continue? [YES]
***********
The installation is completed with the default values and the APPQCIME process starts.
11.Verify that the SE Agent process starts properly. You should see the following message:
CXWS ready to accept connections
12.Verify that the APPQCIME process is running by typing:
$ @sys$common:[opt.appqcime.tools]status
13.Dismount the CD-ROM by typing:
$ DISMOUNT <CD-ROM device name>
14.Remove the CD. Press the Eject button on the CD-ROM drive to take the CD out of the CD-ROM
drive.
NOTE: The CIM Extension starts during the local installation.
Installing the CIM Extension on a Cluster
Follow the steps in ”Installing the CIM Extension on a Standalone Host” on page 193 to install the
CIM Extension for OpenVMS on a Cluster system. The CIM Extension for OpenVMS must be
installed on all nodes of the cluster.
Starting the CIM Extension Manually
This section provides instructions for manually starting the OpenVMS CIM Extension. Be aware that
the management server can only obtain information from a host when the CIM Extension is running
on the host. You must be a superuser for the host system in order to start the CIM Extension.
The CIM Extension provides information within the privileges of the user account that started the
CIM Extension. Only the system account has enough privileges to provide the information the
management server needs.
To manually start the CIM Extension:
1. Log in as system on the OpenVMS host on which you want to start the CIM Extension.
2. Type the following command to start the CIM Extension.
$ @sys$common:[opt.appqcime.tools]start
The following message displays:
STARTING OpenVMS CIME...