Manualshelf

HP Storage Essentials V5.1 Installation Guide Second Edition (Linux Release) (T4283-96055, November 2006)

ManualsBrandsHP ManualsSoftwareHP Storage Essentials Storage Resource Management Backup Mgr 1 TB Tier-2 LTU
221222223224225226227228229230
Storage Essentials 5.1 Installation Guide 203
Installing the CIM Extension
IMPORTANT: You must install the CIM Extension for Tru64 in the default directory.
You can install the CIM Extension for Tru64 one of two ways:
• On a Standalone Host - See ”Installing CIM Extension on a Standalone Host” on page 203.
• On a Cluster - See ”Installing the CIM Extension on a Cluster” on page 204.
Installing CIM Extension on a Standalone Host
To install the CIM Extension using CLI:
1. Login as root.
2. Place the CIM Extension CD-ROM into the CD-ROM on the Tru64 server.
3. Create the /cdrom directory on Tru64 host by entering the following at the command prompt:
# mkdir /cdrom
4. Mount the CIM Extension CD-ROM by enter the following at the command prompt:
# mount /dev/disk/cdromxx /cdrom
where xx corresponds to the cdrom device number.
You can find the cdrom device number by entering the following at the command prompt:
# hwmgr -view devices
5. To install the CIM Extension:
a. Go to the /cdrom/tru64/ directory, as shown in the following example:
# cd /cdrom/tru64/
b. Run the script /tru64_local_install.sh at the command prompt:
#./tru64_local_install.sh
The installation is complete when you are told the following:
Installation of AppStorM Tru64 CIM Extensions was successful.
NOTE: The tru64_local_install.sh command starts the CIM Extension.
6. Eject the CD-ROM by doing the following:
a. Unmount the CD-ROM by entering the following at the command prompt:
# umount /cdrom
where /cdrom is the name of the directory where you mounted the CD-ROM
b. Press the eject/unload button on the CD-ROM drive.
7. Press the Eject button on the CD-ROM drive to take the CD out of the CD-ROM drive.
The CIM Extension for Tru64 starts automatically at boot time by using /sbin/rc3.d scripts.
The CIM Extension uses port 4673 when it starts automatically after a reboot.
8. Type the following at the command prompt to find the status of the CIM Extension:
/opt/APPQcime/tools/status