HP Storage Essentials V5.1 Installation Guide Second Edition (Linux Release) (T4283-96055, November 2006)

Storage Essentials 5.1 Installation Guide 209
• 4673 is the port used by the CIM extension
Stopping the CIM Extension
To stop the CIM Extension, enter the following at the command prompt in the /opt/APPQcime/tools
directory, where /opt is the directory into which you installed the CIM Extension:
# ./stop
Keep in mind the following:
• You must have root privileges to stop the CIM Extension.
• When you stop the CIM Extension, the management server is unable to gather information
about this host.
Rolling Over the Logs
The logging information for the CIM Extension is contained primarily in the cxws.log file, created by
default in the <Installation_directory>/tools directory. The cxws.log file rolls over once
it becomes more than 100 MB. The information in cxws.log is moved to cxws.log.1. When the logs
roll over again, cxws.log.1 is renamed to cxws.log.2 and the information that is in cxws.log is
moved to cxws.log.1. The numbering for the files continues sequentially, for example, cxws.log.3,
with there being a maximum of three backup logs.
• cxws.log - contains the latest logging information
• cxws.log.1 - contains logging information that was previously in cxws.log
• cxws.log.2 - contains logging information that was previously in cxws.log.1
• cxws.log.3 - contains logging information that was previously in cxws.log.2
The cxws_native.log file contains logging information relative to Tru64 native operations. The
configuration information for cxws_native.log is maintained in
/opt/APPQcime/conf/cxws_native.cfg. When the log file size exceeds the LOG_SIZE
parameter specified in the configuration file for the cxws_native.log, the file rolls over. The
information in cxws_native.log is moved to cxws_native.log.old. If
cxws_native.log.old already exists, it is deleted.
Increasing the Native Logging Level
The cxws_native.log contains logging information relative to Tru64 system calls used. The
configuration information for cxws_native.log is maintained in
/opt/APPQcime/config/cxws_native.cfg where /opt is the directory into which you
installed the CIM extension. More detailed logging information can be obtained by increasing the
log level. Set LOG_LEVEL to 3 in cxws_native.cfg and restart the CIM Extension to increase the
log level.
Fulfilling the Prerequisites
Use the commands mentioned in this section to determine if you have the required software.
To verify driver bundle version, enter the following at the command prompt:
# setld -i