HP OpenView Storage Mirroring User Guide (360226-002, May 2004)

13 - 39
LogViewer Messages
The following table describes the standard Storage Mirroring alerts that may be displayed in the LogViewer. The ID appears
in column 7 of the LogViewer, and the message appears in column 8 of the LogViewer.
NOTE: In the following table, con_id refers to the unique connection ID assigned to each connection between a source
replication set and a target.
ID Message Description
0 N/A There are several log messages with this ID#. See the description
in the Message column in the LogViewer file.
7
! Synchronous ioctl returned STATUS_
PENDING
! Failed to reset Replication Flags. Replication
may not be performed correctly.
! Communication with the Storage Mirroring driver is not being
performed correctly. A reboot is required to guarantee
replication and data integrity.
! An error occurred between the Storage Mirroring driver and
recent changes to the replication set. The possible resolutions
are:
! Undo the changes to the replication set
! Stop and restart Storage Mirroring
! Reboot the server
69 Storage Mirroring kernel started on
server_name
The Storage Mirroring service was started on the Storage
Mirroring server specified.
70 Storage Mirroring kernel stopped The Storage Mirroring service was stopped on a Storage
Mirroring server.
71 Originator attempting ip://xxx.xxx.xxx.xxx A source is requesting to connect a replication set to a target
machine.
72 Connection request from ip://xxx.xxx.xxx.xxx A target machine has received a source machine’s request to
connect a replication set to the target.
73 Connected to ip://xxx.xxx.xxx.xxx A source machine has successfully connected a replication set to
a target machine.
74 Connection paused with ip://xxx.xxx.xxx.xxx A network connection between the source and the target exists
and is available for data transmission, but data is being held in
queue and is not being transmitted to the target. This happens
because the target machine cannot write data to disk fast enough.
Storage Mirroring will resolve this issue on its own by
transmitting the data in queue when the target catches up.
75 Connection resumed with
ip://xxx.xxx.xxx.xxx
The transmission of data from the source machine to the target
machine has resumed.
76 Connection failed to ip://xxx.xxx.xxx.xxx An attempt to establish a network connection between a source
machine and target machine has failed. Check your network
connections and verify that the target machine is still online.
77 Connection lost with IP address address The network connection previously established between a source
machine and target machine has been lost. Check your network
connections and troubleshoot to see why the connection was
lost.
78 Auto-disconnect threshold has been reached. The Storage Mirroring queue has exceeded its limit, and the
auto-disconnect process will disconnect the source and target
connection. The auto-reconnect process will automatically
reestablish the connection if the auto-reconnect feature is
enabled. If the auto-reconnect feature is not enabled, you must
first verify that the connection between the source and target has
been broken, and then manually reestablish the connection in the
Management Console.