HP OpenView Storage Mirroring User Guide (360226-002, May 2004)

A - 17
Monitor Script Remove
Monitor Start
Command MONITOR SCRIPT REMOVE
Description Specifies the scripts that should not be run during the failover and failback processes
Syntax
MONITOR SCRIPT REMOVE <type> [monitor]
Options ! type—Any of the following script types:
! PREFAILOVER—Specifies that the file is a pre-failover script to be run on the target before
failover occurs
! POSTFAILOVER—Specifies that the file is a post-failover script to be run on the target after
failover occurs
! PREFAILBACK—Specifies that the file is a pre-failback script to be run on the target before
failback occurs
! POSTFAILBACK—Specifies that the file is a post-failback script to be run on the target after
failback occurs
! SRCPOSTFAILBACK—Specifies that the file is a pre-failback script to be run on the source
after failback occurs
! monitor—Name of the source machine designated as the monitor
Examples
! monitor script remove prefailback
! monitor script remove postfailover
Notes If you do not specify a monitor, the current source designated as the monitor will be used. If you
have not identified a monitor, you will receive an error message stating that a monitor has not been
selected.
Command MONITOR START
Description The configured failover target starts monitoring the source machine that was designated as the
monitor.
Syntax
MONITOR START <monitor> [ON <target_machine>]
Options ! monitor—Name of the source machine designated as the monitor
! target_machine—Name of the target machine that will be monitoring the source machine
Examples
monitor start indy on jersey