HP StorageWorks Storage Mirroring scripting guide (T2558-96074, February 2008)

13 - 25
Monitor Script Remove
Monitor Start
Notes
 If you do not specify a monitor, the current source designated as the monitor will be used. If you
have not identified a monitor, you will receive an error message stating that a monitor has not
been selected.
 Options that contain non-alphanumeric characters must be enclosed in quotation marks.
Command MONITOR SCRIPT REMOVE
Description Specifies the scripts that should not be run during the failover and failback processes
Syntax
MONITOR SCRIPT REMOVE <type> [monitor]
Options  type—Any of the following script types
 PREFAILOVER—The file is a pre-failover script to be run on the target before failover
 POSTFAILOVER—The file is a post-failover script to be run on the target after failover
 PREFAILBACK—The file is a pre-failback script to be run on the target before failback
 POSTFAILBACK—The file is a post-failback script to be run on the target after failback
 SRCPOSTFAILBACK—The file is a post-failback script to be run on the source after failback
 monitor—Name of the source machine designated as the monitor
Examples
 monitor script remove prefailback
 monitor script remove postfailover
Notes  If you do not specify a monitor, the current source designated as the monitor will be used. If you
have not identified a monitor, you will receive an error message stating that a monitor has not
been selected.
 Monitor names that contain non-alphanumeric characters must be enclosed in quotation marks.
Command MONITOR START
Description Initiates failover monitoring
Syntax
MONITOR START <monitor> [ON <target>]
Options  monitor—Name of the source machine designated as the monitor
 target—Name of the target, an IP address on the target, or a virtual IP address
Examples
monitor start alpha on beta
Notes Options name that contain non-alphanumeric characters must be enclosed in quotation marks.