HP StorageWorks Storage Mirroring scripting guide (T2558-96074, February 2008)

7 - 14
3. Initiate the verification process by using the verify command.
Use the
VerifyLogName, VerifyLogAppend, and VerifyLogLimit options with the get and set commands to configure
the verification log. See
Server Settings on page 12-1 for more information on using these commands with a Storage Mirroring
program setting.
Command VERIFY
Description Verifies the integrity of the data between the source and target machines.
Syntax
VERIFY <con_id> [ SYNC [,NEWER] | NOSYNC] [,CHECKSUM | NOCHECKSUM]
[STARTTIME=<mm/dd/yy> [hh:mm]] [EVERY <number> <time_units>]
[ORPHANS | NOORPHANS] [CLEARRESTOREREQUIRED]
Options  con_id—Connection ID assigned to the source/target connection
 SYNC—Synchronizes any data that is different
 NEWER—Synchronizes only those files that are newer on the source than on the target
 NOSYNC—Do not synchronize any data that is different
 CHECKSUM—Compares and/or synchronizes those blocks that are different on the source than on
the target based on checksum comparisons
 NOCHECKSUM—Does not perform a checksum comparison when comparing and/or synchronizing
files
 STARTTIME—Starts the verification process at the time specified
 mm/dd/yy—Date in month/day/year format when the verification process will begin
 hh:mm—Time in hour:minute format using the 24-hour clock when the verification process will
begin
 EVERY—Repeat the verification process at the frequency specified
 number—Length of time to repeat the verification process
 time_units—Minutes (min), hours (hr), or days (day)
 ORPHANS—Moves or deletes orphan files on the target
 NOORPHANS—Does not move or delete orphan files on the target
 CLEARRESTOREREQUIRED—Clears the restore required flag and initiates the verification
Examples
 verify 1
 verify 2 sync, newer
 verify 2 every 2 hr
Notes The default verification settings are sync, checksum, and noorphans.