HP StorageWorks Storage Mirroring scripting guide (T2558-96074, February 2008)

12 - 5
DefaultProtocol The default protocol
Values: 1 IP protocol
Default: 1
GUI Setting
: Server Properties, Network tab, Interface, Default Protocol
TCP/IP is the only protocol currently supported.
DirUNetPort Port used for directed UDP communications
Values:
1025 - 65535
Default: 1105
GUI Setting
: Server Properties, Network tab, Interface, Network, Status Listen Port
Management Console, File, Options, Network, Status Transmit Port
If you change this value, the source service must be stopped and restarted to implement the
change.
DisableAttribute
Replication
Specifies whether or not attributes (read-only, hidden, and so on) are replicated to the target
Values: 0 Enable attribute replication
1 Disable attribute replication
Default: 0
GUI Setting: None
DropOpOnHandle
Error
Determines if an additional attempt is made to access a file by a Microsoft API call if the Storage
Mirroring call fails.
Values: 0 When opening a file using the Storage Mirroring driver fails, attempt to open the file
using
the Microsoft Win32 API
1 When opening a file using the Storage Mirroring driver fails, skip the file and document it
in the Storage Mirroring log
Default: 1
GUI Setting
: None
If the value is set to
0 and the Win32 call also fails, Storage Mirroring will skip the file and
document it in the Storage Mirroring log
DTSetupType Used by the Storage Mirroring installation program to maintain the installation settings for an
upgrade
DumpHiveInterval
Minutes
Specifies how often, in minutes, a snapshot of the registry is taken as backup in case the live
registry is not usable at failover
Values: any integer
Default: 240
GUI Setting
: None
This option is for Full-Server Failover Option and Server Recovery Option.
EmailEnabled Specifies if e-mail notification is enabled
Values: 0 E-mail notification is disabled
1 E-mail notification is enabled
Default: 0
GUI Setting
: Server Properties, E-mail Notification tab, Enable notification
This is a read-only setting. If you change this setting using the DTCL SET command or via the
registry editor, e-mail notification will not automatically start. You must use the GUI or the DTCL
EMAIL ENABLE command to start e-mail notification.
Server Setting Description