HP StorageWorks Storage Mirroring Scripting Guide (T2558-96327, April 2009)

10 - 2
2. After you have created a snapshot schedule, you can view the configuration of the schedule by
using the
snapshot schedule display command.
3. You can disable a snapshot schedule, without losing the schedule configuration, by using the
snapshot schedule disable command.
4. You can enable a disabled snapshot schedule by using the snapshot schedule enable
command.
Command SNAPSHOT SCHEDULE DISPLAY
Description Displays the snapshot schedule
Syntax
SNAPSHOT SCHEDULE <con_id> DISPLAY [ON <target>]
Options
 con_id—Connection ID assigned to the source/target connection
 target—Name of the target, an IP address on the target, or a virtual IP
address
Examples
snapshot schedule 1 display
Notes Target names that contain non-alphanumeric characters must be enclosed in
quotation marks.
Command SNAPSHOT SCHEDULE DISABLE
Description Disables a snapshot schedule
Syntax
SNAPSHOT SCHEDULE <con_id> DISABLE [ON <target>]
Options
 con_id—Connection ID assigned to the source/target connection
 target—Name of the target, an IP address on the target, or a virtual IP
address
Examples
snapshot schedule 1 disable
Notes
 This command only disables the snapshot schedule for this connection so
that it will not run. It does not clear the snapshot schedule parameters.
 Target names that contain non-alphnumeric characters must be enclosed
in quotation marks.
Command SNAPSHOT SCHEDULE ENABLE
Description Enables a disabled snapshot schedule
Syntax
SNAPSHOT SCHEDULE <con_id> ENABLE [ON <target>]
Options
 con_id—Connection ID assigned to the source/target connection
 target—Name of the target, an IP address on the target, or a virtual IP
address
Examples
snapshot schedule 1 enable
Notes Target names that contain non-alphanumeric characters must be enclosed in
qutoation marks.