HP StorageWorks Storage Mirroring Virtual Infrastructure user's guide (T2558-96095, April 2008)
Table Of Contents
- Introducing Storage Mirroring for Virtual Infrastructure
- Install Storage Mirroring for Virtual Infrastructure
- Getting Started with Storage Mirroring for Virtual Infrastructure
- Configure your VMware ESX server to use a root account
- Configure your VMware ESX server to use a non-root account
- Configure the SCP timeout
- Configure the VirtualCenter operation timeout
- Navigate the Storage Mirroring for Virtual Infrastructure interface
- Find out more information about tasks
- Start Storage Mirroring for Virtual Infrastructure
- Connect to the Administrative Servers
- Set up the E-mail Server
- Manage ESX Servers
- Set up Protection for a Virtual Machine
- Monitor your Protected Virtual Machines
- Pre-Staging Data on the Target
10
Log off administrative servers
Logging off clears the current credentials so that you will be prompted to enter credentials on your
next logon.
To log off the servers, click the Disconnect
button in the left pane. A box that identifies the server(s)
that you are currently logged in to will appear. If you click OK, the Connect to SMVI Servers
window will appear so that you can log in to different SMVI and VirtualCenter servers.
Manage activation codes
To enter an additional SMVI activation code, select Go, Manage Activation Codes. The Manage
Activation Codes window will appear.
Each valid activation code corresponds to a number of slots, where each slot represents the capacity
to protect a single virtual machine. The slots are not bound to a specific socket or piece of hardware.
Instead, a slot can be used to protect a virtual machine on any server in your VI enterprise. Each
time a protection is created using the wizard, the application will automatically update the number of
slots available for subsequent protections.
Type in a new SMVI activation code to be used for a protected virtual machine, then click Add. When
you are finished, click Done.