HP StorageWorks Storage Mirroring for Linux User's Guide (T2558-96078, February 2008)

14 - 15
FailoverHostname Automatically removes the host SPN (Service Principle Name) from Active Directory on the
source
Values:
(
0) Disabled
(
1) Enabled
Default: 0
If you are using Active Directory, this option should be enabled or you may experience problems
with failover.
FailoverOnRoute
Failure
Determines if failover will occur when receiving a router message back from an IP address on the
network
Values:
(
0) Failover will not occur when receiving a destination host unreachable message
(
1) Failover will occur when receiving a destination host unreachable message
Default: 1
FCCHelpPath The path and file name to the Failover Control Center online help file
Default: c:\Program Files\OpenView\Storage Mirroring\online help\fcc\ wwhelp.htm
Do not change this value or the online help will not work.
FileQueueSize When a mirror is started, one thread reads from the disk and builds the file queue. Another set
of threads reads files off of the queue and sends them to the target. This setting is the maximum
size of the queue in entries. If you had 100 files to be mirrored and this was set to 16 (the default
value), the first thread would fill the queue to a maximum of 16 entries.
Values: 1 - 65535
Default: 16
This value must be set prior to starting the mirror process. The higher the number, the more
memory that is used.
ForceReplaceOn
Failover
Specifies additional failover options
Values:
(0) Use standard failover add / replace settings with no additional settings
(
1) Replace the target server name with that of the source and add the source IP address
(2) Add the source server name to the target and replace the target IP address
(
3) Replace the target server name with that of the source and replace the target IP address
HBExternalRate Number of seconds between heartbeats
Values: 0 - 65535
Default: 3
HP recommends a value that is less than
10 (see HBTTL). Zero (0) turns the heartbeats off.
HBInternalRate This entry is no longer used.
HBLoopback This entry is no longer used.
HBTrace Specifies whether the heartbeat debugging information is generated
Values:
(0) not generated
(
1) Generated
Default: 0
Program Setting Description