HP StorageWorks Storage Mirroring for Linux Scripting Guide (T2558-96319, June 2009)

14 - 40
Schedule Window
Set
Command SCHEDULE WINDOW
Description Sets criteria to only allow transmissions during a certain period of time
Syntax
SCHEDULE <target> WINDOW <hh:mm> TO <hh:mm>
Options
 target—Name of the target, an IP address on the target, or a virtual IP
address Depending on the network route Storage Mirroring uses to access
the target, you may need to specify the fully qualified domain name.
 hh:mm—Time in hour:minute format using the 24-hour clock. The first
time is when the transmission will begin and the second time is when the
transmission will end.
Examples
schedule beta window 23:00 to 06:00
Notes
 Establishing a transmission window by itself is not sufficient to start a
transmission. You will need to specify a start criteria.
 Target names that contain non-alphanumeric characters must be
enclosed in quotation marks.
Command SET
Description Modifies the value of a Storage Mirroring program setting for the specified
server
Syntax
SET <setting>=<value> [machine]
Options
 setting—See the table Storage Mirroring Server Settings on page
13-2 for a complete list of the Storage Mirroring program settings
 value—See the table Storage Mirroring Server Settings on page 13-2
for a complete list of the Storage Mirroring program settings
 machine—Name of the machine
Examples
set netport=1100
set DefaultAddress="129.12.34.3"
Notes
 Some settings, although immediately applied to Storage Mirroring, will
not take effect until the service is restarted.
 If you do not specify a machine name, the value from the current source
will be updated. If you have not identified an active source, no changes
will be made.
 Options that contain non-alphanumeric characters must be enclosed in
quotation marks.