HP StorageWorks Storage Mirroring for Linux Scripting Guide (T2558-96319, June 2009)

13 - 3
AllMustFail Specifies whether or not all IP addresses must fail for failover to take place
Values:
0 any IP address can fail
1 All IP addresses must fail
Default:
1
GUI Setting: Failover Control Center, Monitor Settings, Failover Trigger, All
Monitored IP Addresses Fail
AutoReconnect Specifies whether to reinstate the target connection(s) when the source
machine is brought online after a source machine failure
Values:
0 Do not reconnect
1 Reconnect
Default:
1
GUI Setting: Server Properties, Setup tab, Source Module Startup Options,
Automatically Reconnect During Source Initialization
AutoRemirror Specifies whether to remirror when a source is brought online after an
auto-disconnect
Values:
0 Do not remirror
1 Perform a file differences checksum mirror
2 Perform a full mirror
3 Perform a file differences mirror
4 Perform a date comparison mirror. Send data only if the source data is
newer than the target data.
Default:
1
GUI Setting: Server Properties, Setup tab, Source Module Startup Options,
Perform Remirror After Auto-Reconnect
AutoRemirrorRetry Specifies how often, in seconds, the source should check for connections that
have been reconnected but still need to be remirrored
Values: any integer
Default:
30
GUI Setting: None
AutoRetransmit Determines whether or not a source that has lost its connection with a target
will attempt to reconnect to the target
Values:
0 Do not attempt to reconnect
1 Attempt to reconnect
Default:
1
GUI Setting: None
BackupDir Location on the target of the backup of the replication sets
Values: any valid path
Default: the location where the Storage Mirroring files were installed
GUI Setting: None
Server Setting Description