HP StorageWorks Storage Mirroring for Linux User's Guide (T2558-96078, February 2008)

7 - 12
Options  repset—Name of the replication set
 target_machine—Name of the target machine, an IP address on the target machine, or a virtual IP
address
 MAP EXACT—Specifies that the replication set data will be sent to the same logical volume on the
target
 MAP BASE—The replication set data will be sent to the locations specified below:
 connect repset to target—If mappings are not specified with the command, map base
will be used by default. The data will be replicated to
/SrcName/RepsetName/SrcVolName
on the target machine
 connect repset to target map base target_path—Substitute a complete path, including
the volume, for
target_path and the data will be replicated to /target_path/SrcVolName on
the target machine
 connect repset to target map base source_path TO target_path—Custom location
that specifies each directory on the source and where that data will be copied to on the target
machine
 ...—Indicates that the source_path TO target_path option can be used more than once for each
source directory in the replication set
 MIRROR—Automatically initiates a mirror when the connection is established
 NOMIRROR—Does not initiate a mirror when the connection is established
 REPLICATE—Automatically initiates replication when the connection is established
 NOREPLICATE—Does not initiate replication when the connection is established
 MONITOR—Specifies that the target is going to monitor the specified source machine for failover.
The source machine must have already been defined as a monitor machine.
 NOMONITOR—Specifies that the target is not going to monitor the source machine for failover
 ORPHANS—Removes orphan files on the target
 NOORPHANS—Does not remove orphan files on the target
Examples
 connect “Customer Data” to jersey map exact
 connect marketing to jersey map base /home/username
Notes  The default settings for this command are mirror, replicate, nomonitor, and noorphans.
 Options that contain non-alphanumeric characters must be enclosed in quotation marks.
 If you are establishing a connection within a NAT environment, you will need to specify the port
of the router after the IP address (separated by a colon).