HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

137 of 739
Selecting Exchange source and target servers
If you have not done so already, launch the Protecting an Exchange Server workflow.
The Application Manager will automatically attempt to populate the Source Server and
Target Server lists with any servers in the specified domain that are running Exchange.
If you select a source/target pair for which you have previously enabled and disabled
protection, you may use the existing configuration settings (provided that the
source/target connection is not currently active, in which case the existing settings will
always be used). When you select Configure or Validate, a prompt will appear asking if
you want to re-use the previous configuration information. Click Yes to re-use the
previous information, or click No to revert to the Application Manager default settings.
Note:
If the IP address(es) for the source or target server have changed since you
originally configured protection (for example, if you configure the source or
target in a staging area and then send it to a production location), you must re-
configure the protection settings. When you are prompted to re-use the previous
protection configuration, click No, then click the Configure Protection button.
1. In the Source Server field, select the Exchange server that you want to protect. If
this is your first time to log in to the selected server, you will be prompted to enter
server login information. For more information about logging in to servers, see
Entering server login information.
Note:
You cannot protect a server if it is already functioning as a target server.
If you attempt to select a source that is currently unavailable, a prompt will
appear stating that the source is not available and that if the source is failed
over, you should first select the target.
If you select the target, then select the source (as recommended in the prompt),
the same prompt appears (though you would expect to get a prompt to failover).
The ability to failover using the Application Manager will not be available until a
failover condition has been met in accordance with the failover monitor settings
set on the Monitoring tab.
2. In the Target Server field, select the backup Exchange server that will protect the
source server in the event of a failure. The target must be in the same Exchange
admin group as the source.
Notice that after the source and target servers are selected, the Protection Status on the
Monitor tab changes to Unprotected.