HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

269 of 739
Icon Validation Status
addressed prior to failover. Can be fixed by Application Manager.
Warning, Not Fixable—The Application Manager detected an issue that should
be addressed prior to failover. Must be fixed manually.
Note:
● If you run a validation against a source/target pair that is in a Protected
state and the validation detects issues with the target (such as the target is
missing or contains incorrect data), the Fix or Fix All button will be
disabled. You must disable protection for the source/target pair before you
can fix the issue. Then, you can re-enable protection.
● If the IP address(es) for the source or target server have changed since
you originally configured protection (for example, if you configure the
source or target in a staging area and then send it to a production
location), you must re-configure the protection settings. When you are
prompted to re-use the previous protection configuration, click No, then
click the Configure Protection button.
● If you are configuring protection for a SQL database using Database Only
mode and the database is online on the target, the database cannot be
taken offline on the target by using the Fix function if it has a SQL Server
replication publication. The publication will have to be deleted using the
SQL Server management tools before the database can be taken offline.
● For SQL 2000 servers, the Application Manager may hang when
validation is re-run after disabling protection in the same session. To work
around this issue, after disabling the protection, stop then restart the
Application Manager, then validate or enable protection.
Enable protection for an application server
If you have not done so already, launch the Application Manager.
Based on the current protection status, the Enable/Disable Protection button (on both
the Setup and Monitor tabs) and menu options will be updated to display the available
actions. If the Application Manager is not in a state that will allow protection to be
enabled, the Enable/Disable Protection button and menu option will be grayed out
(disabled).
After monitoring has been enabled for a source/target pair, you can view the status of the
monitored connection on the Monitor tab.