HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

327 of 739
1. Compression—Select the compression level (None, Low, Medium, or High) to
use when sending data from the source to target server.
2. Send data to this target route—Select the IP v4 or IP v6 address on the target
server to which you want to send data from the source.
3. Limit Bandwidth—You can specify a limit for the bandwidth to be used by source-
to-target communications for this protection job. Select the Limit Bandwidth
checkbox, then enter a value (in kilobits per second) that bandwidth cannot
exceed.
4. Fail over automatically if the target server cannot contact the source server—
If you want the replica virtual machine to stand in for the source server when the
source is inaccessible, select this checkbox.