HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

397 of 739
Monitoring an application workload
If you have not done so already, launch the Storage Mirroring Recover Application
Manager by selecting Start, Programs, HP Storage Mirroring, Recover, Storage Mirroring
Recover Application Manager.
After the initial mirror, your source server is protected.
To change whether failover monitoring is enabled, click the Enable/Disable Monitoring
button at the bottom of the window, or select either Enable Monitoring or Disable
Monitoring from the Actions menu.
Note:
● You cannot use both the Failover Control Center and the Application
Manager interfaces to monitor a source/target pair at the same time. HP
recommends that all monitoring occur from the Application Manager
interface. If both interfaces are open and a failover condition occurs,
failover will not be initiated until the failover prompt is cleared in both
interfaces.
● If the source is rebooted, the "Details" may go to an "Unknown" status
until the Application Manager is closed and re-opened.
Protection status
Monitoring status
Mirror status
Replication status
Transmit mode
Target status
Protection status states
The following table describes the possible protection status states.
Protection
Status
Description
Unprotected No Storge Mirroring connection exists
Warning
Storge Mirroring connection exists, but has issues (such as with target
state, mirroring, or replication). For example, if the mirror has been
paused outside of the Application Manager or if the target is down.
See details for more information.
Protection Status States