HP StorageWorks Storage Mirroring Recover User's Guide (T5437-96008, November 2009)

524 of 739
a. If you want to use the most recently replicated data on the target, select Use
live data.
b. If you want to use the data from a snapshot, select Revert to specified
snapshot, then select the snapshot in the list. To help you understand what
snapshots are available, use the Type and Status columns. The Status
indicates the state of the connection between the source and target at the
time the snapshot was taken. The Type information is displayed in the
following table.
Type Description
Scheduled This snapshot was taken as part of a periodic snapshot.
Deferred
This snapshot was taken as part of a periodic snapshot, although it did not
occur at the specified interval because the connection between the source
and target was not in a good state.
User
Request
This snapshot was taken manually by a user.
4. Click Initiate Failover to begin failover process. After you select Initiate Failover,
the failover process will begin and the Protection Status and Failover/Monitoring
Status indicators on the Monitor tab will display Failing Over.