HP StorageWorks Storage Mirroring Replicate User's Guide (T5437-96023, November 2010)

Recovery Page 93 of 214
l Virtual Disk Type—For each volume you are protecting, specify the type of
disk, Dynamic or Fixed, that will be created on the virtual machine.
l Controller Type—Specify the type of controller, IDE or SCSI, to be used for
each volume.
Note: The system volume must be an IDE controller. In addition, up to two
more volumes can be attached to an IDE controller. If you are
protecting more than three volumes on the source, you will need to
install the Hyper-V Integration Components to acquire a SCSI device.
See your Hyper-V documentation for more information.
If your source is Windows 2003 or Windows 2008 with no service
packs and you have selected a SCSI controller, you will need to
manually install the Hyper-V Integration Components after failover to
attach these volumes to the replica virtual machine.
9. Click Next to continue.
10. Specify the volume or cluster storage volume and the folder on the target server
where the new virtual machine will be created. You can only select a volume that
has enough free space available.
11. Click Next to continue.
12. Configure the new virtual machine that will be created and will become the source
after the recovery.