HP StorageWorks Storage Mirroring user's guide (T2558-96073, February 2008)

14 - 23
Configuring queuing
You should configure queuing on both the source and target.
1. Right-click the server on the left pane of the Management Console and select Properties.
2. Select the Queue tab.
3. Specify the Folder where the disk queue will be stored. Storage Mirroring displays the amount of free space on the
volume selected. Any changes made to the queue location will not take effect until the Storage Mirroring service has
been restarted on the server.
Select a location on a volume that will have minimal impact on the operating system and applications being protected.
For best results and reliability, this should be a dedicated, non-boot volume. The disk queue should not be on the same
physical or logical volume as the data being replicated. Also, for best results, select a location that is on a different
volume as the location of the Windows pagefile.
Although the read/write ratio on queue files will be 1:1, optimizing the disk for write activity will benefit performance
because the writes will typically be occurring when the server is under a high load, and more reads will be occurring
after the load is reduced. Accordingly, use a standalone disk, mirrored (RAID 1) or non-parity striped (RAID 0) RAID
set, and allocate more I/O adapter cache memory to writes for best performance. A RAID 5 array will not perform as
well as a mirrored or non-parity striped set because writing to a RAID 5 array incurs the overhead of generating and
writing parity data. RAID 5 write performance can be up to 50% less than the write performance of a single disk,
depending on the adapter and disk.
Another option is to use a solid state disk, which are hard drives that use RAM instead of disk platters. These devices are
typically quite costly, but they will provide superior performance as a queuing device when the best performance is
required.
NOTE: Scanning the Storage Mirroring queue files for viruses can cause unexpected results. If anti-virus software
detects a virus in a queue file and deletes or moves it, data integrity on the target cannot be guaranteed.
As long as you have your anti-virus software configured to protect the actual production data, the
anti-virus software can clean, delete, or move an infected file and the clean, delete, or move will be
replicated to the target. This will keep the target from becoming infected and will not impact the Storage
Mirroring queues.