HP StorageWorks Storage Mirroring user's guide (T2558-96073, February 2008)

19 - 5
Log messages
The following table describes some of the standard Storage Mirroring alerts that may be displayed in the log files. The ID
appears in column 7 of the log file, and the message appears in column 8.
NOTE: In the following table, con_id refers to the unique connection ID assigned to each connection between a source
replication set and a target.
ID Message Description
0 N/A There are several log messages with this ID#. See the
description in the Message column in the LogViewer file.
7
 Synchronous ioctl returned STATUS_
PENDING
 Failed to reset Replication Flags.
Replication may not be performed
correctly.
 Communication with the Storage Mirroring driver is not
being performed correctly. A reboot is required to guarantee
replication and data integrity.
 An error occurred between the Storage Mirroring driver and
recent changes to the replication set. The possible
resolutions are:
 Undo the changes to the replication set
 Stop and restart Storage Mirroring
 Reboot the server
69 Storage Mirroring kernel started on
server_name
The Storage Mirroring service was started on the Storage
Mirroring server specified.
70 Storage Mirroring kernel stopped The Storage Mirroring service was stopped on a Storage
Mirroring server.
71 Originator attempting ip://xxx.xxx.xxx.xxx A source is requesting to connect a replication set to a target
machine.
72 Connection request from
ip://xxx.xxx.xxx.xxx
A target machine has received a source machine’s request to
connect a replication set to the target.
73 Connected to ip://xxx.xxx.xxx.xxx A source machine has successfully connected a replication set
to a target machine.
74 Connection paused with
ip://xxx.xxx.xxx.xxx
A network connection between the source and the target
exists and is available for data transmission, but data is being
held in queue and is not being transmitted to the target. This
happens because the target machine cannot write data to disk
fast enough. Storage Mirroring will resolve this issue on its own
by transmitting the data in queue when the target catches up.
75 Connection resumed with
ip://xxx.xxx.xxx.xxx
The transmission of data from the source machine to the target
machine has resumed.
76 Connection failed to ip://xxx.xxx.xxx.xxx An attempt to establish a network connection between a
source machine and target machine has failed. Check your
network connections and verify that the target machine is still
online.
77 Connection lost with IP address address The network connection previously established between a
source machine and target machine has been lost. Check your
network connections and troubleshoot to see why the
connection was lost.
78 Auto-disconnect threshold has been
reached.
The Storage Mirroring queue has exceeded its limit, and the
auto-disconnect process will disconnect the source and target
connection. The auto-reconnect process will automatically
reestablish the connection if the auto-reconnect feature is
enabled. If the auto-reconnect feature is not enabled, you must
first verify that the connection between the source and target
has been broken, and then manually reestablish the connection
in the Management Console.