HP StorageWorks XP24000 Audit Log User and Reference Guide, v01 (AE131-96003, June 2007)

Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in the following table.
Table 152 Detailed Info: Add RCU Operation
DescriptionItem
Indicates a serial number of the registered RCU device.S/N
The LDKC number of the connected LDKC.MCU LDKC
The LDKC number of the paired LDKC.RCU LDKC
The path group ID of the registered RCU. When the path group ID is default setting,
Default is output.
Path Gr. ID
The controller ID of the registered RCU device.Controller ID
The CU number of the connected CU.MCU
The CU number of the paired CU.RCU
The SSID of the registered RCU.SSID
The port number of MCU.MCU Port
The port number of the registered RCU.RCU Port
The number of set minimum paths.Min. Path
The value of set RIO MIH (Remote I/O Missing Interrupt Handler) timer (wait time until
data copy from MCU to RCU is completed). The unit is second.
MIH Time(s)
The round-trip response time set (delay time for round-trip remote I/O). The unit is
millisecond. This value is output when HP XP Continuous Access Software or HP XP
Continuous Access Software for Mainframeis used.
Round Trip
Time(ms)
The set incident of the RCU. This value is output only when HP XP Continuous Access
Software for Mainframe is used.
Incident
“only to RCU host” or “to any host” is output.
Indicates whether CGROUP (FREEZE/RUN) PPRC TSO command support is enabled or
disabled. This value is output only when HP XP Continuous Access Software for Mainframe
is used.
FREEZE
Enable or Disable is output.
The number of port pairs set.Num. of Port Pairs
Sample Audit Logs162