HP StorageWorks XP24000 Audit Log User and Reference Guide, v01 (AE131-96003, June 2007)

Note 3: When you perform two or more LUN Manager operations, the following conditions apply:
• When you perform two or more operations on one target and select Apply, the log information
is output as one entry.
• When you apply two or more settings at one time, the log information is output according to the
priority shown in Table 249.
If the priority is the same, the log information is output in the order of the operations performed.
Table 249 LUN Manager Operation and Priority of Audit Log Output
PriorityTarget of OperationOperation
2LUDelete
1Host Group
1WWN
2Disk Controller (DKC ) connection
WWN
4LUAdd
3Host Group
3WWN
3Host GroupChange
3WWN
3Changing Host Mode
4Command Device
4Command Dev. Security
OFF: 3LUN Security
ON: 1
• If you perform the following operations at the same time:
• Add –> Delete: The operations cancel each other and no log information is output.
• Change –> Delete: Log information is output for the Delete operation.
• Change 1 –> Change 2: Log information is output for the Change 2 operation.
• Add –> Change: Log information is output as an Add operation, but the contents of the setting
are output according to the setting of the Change operation.
• If you have deleted a host group, the following operations performed for that Host Group are not
output as log information:
• Changing host mode
• Changing Host Group
• Adding or deleting paths
• Adding, changing, or deleting WWN
XP24000 Audit Log User and Reference Guide 267